60 CM PRESSFLEX® MODULES FOR HOT WELDING FABRICS.

MODULARITY AND EVEN PRESSURE IN HOT WELDING FABRICS.

ZPARROW-DOWNLOAD-PDF-HOT-WELDING-FABRICS-PRESSFLEX-60-cm-MODULES-PRESSE-FOTO3
ZPARROW-DOWNLOAD-PDF-HOT-WELDING-FABRICS-PRESSFLEX-60-cm-MODULES-fotopag11-1
ZPARROW-DOWNLOAD-PDF-HOT-WELDING-FABRICS-PRESSFLEX-60-cm-MODULES-barra_riscaldata-1

MODULARITY AND EVEN PRESSURE

The machines for hot welding fabrics are equipped with an upper heated sealing bar that is continuous, and a special rubber tape insert makes it flexible and slightly compressible.

The pressure is discharged to the lower bar with a set of pneumatic cylinders set up along the width of the machine, placed at every 60 cm.

Each of these applies pressure to two points, and between the two points there is a special linearity regulation screw.

This type of construction guarantees excellent adherence to the lower bar and consequently the resulting pressure is extremely uniform irrespective of the press width.

The utility model has been deposited and registered as PRESSFLEX®.

The machine for hot welding fabrics has a lower bar in the standard press that is also heated. The temperatures above and below can be adjusted independently.

On request, and at no extra charge, the bottom part can be supplied with a non-stick elastic rubber surface that is resistant to high temperatures.

Would you like to try hot welding textiles with our hot welding machines on YOUR fabrics?

Then contact us today by filling out the form below and we will test hot welding on your fabric FOR FREE!