The pump for viscous fluids M100/P89 model is equipped with a very sturdy reciprocating pneumatic motor with a highly precise and reliable air reversing distribution system.

The pneumatic piston pump flow can be adjusted with considerable precision by regulating the air supply using the needle valve.

This model is suitable for pumping medium to high viscosity fluids when required flows are up to 3000 l/h for primarily output.

It can also function as a pump for chemical products, since it can be fitted with specific filters for chemical products, and the pumping power can reach approximately 9 bar (135 psi).

This vertical pump is a “divorced” type, in that the P89 pumping piston can be easily divided into two parts for cleaning; using a clean spare piston also offers the benefit of reducing down time to only a few minutes.

(*) The flow capacities above are with water at 20°C, free flow opening and air supply at 6 bar.

The flow capacity depends on the viscosity of the product and the air supply pressure.

The pumping part is deliberately short so that the part immersed in the product is soiled as little as possible; it is therefore recommended to adjust immersion with it suspended on a lifting and lowering system using the eye bolt.

This  100% made in Italy pump, produced in-house by us,  is primarily made in stainless steel with details in bronze and gaskets in high-quality virgin PTFE.

The upper part of the motor body is in special anti-corrosion aluminum and stainless steel.

Do you have a very viscous product that is difficult to pump?

Contact us today and we will carefully evaluate the viscosity of the product to recommend the most suitable pump for your specific needs! With over 40 years of experience, we have never met a client that we could not satisfy!